Juniper SRX
The Juniper integration reads SRX firewalls (and other JunOS devices) over SSH. It runs on an Integrator inside your network, so the device's management interface is never exposed to the CyberOptix CTEM Platform.
It is read-only. The integration reads the configuration and operational state as JSON, and never enters configuration mode.
What it collects
| Sync | Collects |
|---|---|
| Configuration backup | The configuration in display set form, with secrets stripped on the Integrator before it leaves your network, versioned whenever it changes; zone-pair and global security policies in evaluation order |
| Configuration review | Every configuration backup and NAT sync is reviewed against the configuration review checks, and what they find is raised as vulnerabilities on the device |
| Network discovery | Interfaces with their security zones, the networks they are addressed into, and the routing table of every routing instance |
| Host discovery | ARP entries |
| Exposure correlation | Static, destination and source NAT rules, so an address reachable from outside is tied to what sits behind it |
What the firewall reports is kept as its own record, alongside hosts and subnets rather than written into them.
Create a read-only account
set system login class optix-read permissions [ view view-configuration ]
set system login user optix class optix-read authentication plain-text-password
Allow SSH from the Integrator's address if the routing engine is protected by a loopback filter.
Connect it
- Under Integrations, add Juniper with the device's management hostname, the SSH port if it is not 22, and the account's username and password.
- In the integration's settings, assign the Integrator that can reach the device.
- Enable the syncs you want.
Host keys
The first connection accepts the device's SSH host key and records it on the integration; every later connection must present the same key. If you replace the key, clear the pinned host key in the integration's settings so the new one is recorded.